What is the installation process of the mold?
Before installation, it should be confirmed that the tool edge is sharp, there is no breakage on the concave die edge, and there is no missing Angle on the convex die.If there is a break or missing Angle, please first sharpen the edge.
A silicon steel sheet shall be inserted between the upper and lower dies before joining the mould to prevent the knife edge from being damaged due to the handling process.
Before installing the press, grind off the bottom and burrs with a pumice stone.If there are burrs or garbage on the upper and lower surface of the mould, the burrs of the blanks will be poor.
To adjust the slider stroke and tighten the upper die at an appropriate position, it is necessary to ensure that the handle or the plane of the die holder and the bottom of the slide block are closely connected, and the screw of the lower die pressing plate is lightly pressed.Then, adjust the slider upward and take out the middle silicon steel sheet.Loosen the lower die plate screw, and adjust the slider downward until the convex die enters the mandibular die 3 ~ 4mm to tighten the lower die plate screw.When the new mould is blanking, the convex die must enter the human concave die 3 ~ 4mm.
Flow up the slider to the dead end position, adjust the press rod stop screw until it is properly tightened, and then turn it a few times to check whether the die and press mechanism are working normally.If there are no exceptions, production can begin.